With a Cable Box: Setting the Cable Channel
The Cable Channel works with CABLE on the remote. If the Cable Channel is set, pressing CABLE selects the channel to
see cable channels. The Cable Channel setting depends on whichchannel your cable box must be on to see cable
channels. The channels usually used are 02, 03, 04, 05 or 06. Consult your cable company for more information.
1. Select the Setup menu
A. Press "IVto set the remote to control the
"IV.
B. Press MENU to select the Setup menu.
This menu is white.
13
;ontrols Alarm Adjust_
2. Highlight Cable Channel
A. Press CHANNEL down to move down the
menu until Cable Channel is highlighted.
B. Press -I-to underline the channel. Controls Alarm Ad
13
3. Enter channel number
Enter the number for your cable box, either 02,
03, 04, 05, or 06. Press CHANNEL down until
"Disabled" is displayed to turn this feature off.
13
Controls Alarm Ad
4. Press DISPLAY or DONE
Press DISPLAY or DONE to remove the menu
from the screen.
13
To Next Page
Loading...
