Theliquid crystaldisplay(LCD) panelis madeby highlyprecisetechnology.More
than99.99%of its pictureelements(pixels)areeffective,butsome(lessthan0.01%)
mayappearascoloredbrightdots. Thisdoesnot indicatea fault astheLCD panel
stretchesthelimits of currenttechnology.
Adjusting the Brightness Moving the LCD Monitor
The LCD brightness can be adjusted
during both recording and playback. The
recorded video is not affected. To adjust
the brightness you must open the LCD
monitor.
The LCD screen can be moved from a 90 °
to 290 ° angle. When you turn the LCD
monitor screen facing the same direction
as the lens, the image displayed on the
LCD monitor is reverse to that seen in a
l.
.
.
Press OPEN to open the LCD
monitor.
Set the CAM/OFF/VCR switch to
CAM or VCR.
Use the Bright control on the side of
the LCD monitor to adjust the
brightness of the LCD screen.
mirror.
Top of camcorder
Note: Do not pushthe LCD monitor further
than illustrated damage could result.
Ca::_'_ _,_:_ _ueh th_LCDscreen.with The LCD monitoi _ho[:_ ei6sed ifir:i_ ::_:_:i:::i
::_:::_fige_i:_:[h_en:c_ld:ge[:_ _d tilted. : ::::_::__;::._:_:!_:ii_:i:i:::i:i::i:_._::::::i::::_!:-_:_i,:::::ii_i:_::_
_sereen_omes dirty, use a solt c_oth to wipe w..... " . i:-::: :: _ :-:::::-:
:::i::_:i:_:_:_:,_: .... parallel _ththe camct_rde_,_!_ff_o_we_i::t0i::
:otr:tlae a_rt. close the monitor while it:faces the same:: :
:_f_:::_c_corder is used in a cold place and direction as the!lens: of it i_:$_o_all _t_uid
:too_:eold,theLCD screen will be dim damage the monitor. :: ....-:::_::............. :::_
ifo_:_i::_!_ after the power is turned on. When Do not dismantle the LCD monitor as this: :
29
To Next Page
Loading...
