PELLET STOVES Chapter 4
red
INSTALLATION AND USE MANUAL
page 38
Operation Technical service - Rights reserved - Reproduction prohibited
SET
TURBO
1
2
64
3
5
!
on
SET
TURBO
1
2
64
3
5
!
OFF
20 41
:
4.7. FIRST LIGHTING
You are now ready to light your stove.
The following is a brief description of how to light and extinguish your
stove to satisfy your curiosity and expectations.
4.7.1. Lighting the stove
To light the stove from the panel, press the button for a few
seconds.
“Fan Acc” appears on the display followed by “Load Wood”.
The start-up phase last for 15 minutes, the panel displays (8)
show the room temperature on the upper display and the
temperature of the water in the stove on the lower display. The
stove is ON!
If you have completed the lighting phase and there is no flame (the
stove is not lit), the display (8) will show the message “Alarm no
ignition” accompanied by an intermittent sound alarm. In this case,
turn the stove off by pressing for a few seconds on the button
.
The display (8) will show the message “Off / current time".
Check the grate. Are there pellets?
If this is the first lighting, the fuel which has to
travel from the hopper to the grate is not arriving in
time or in the properly programmed amount. In this
case the grate will either be empty or will contain
very few pellets.
REMOVE ANY PELLETS FROM THE BURNER AND
REPEAT IGNITION BY PRESSING FOR A FEW
SECONDS ON THE BUTTON
.
After repeated ignitions, if no flame appears even though there is a
correct supply of pellets, there may be a problem with the components
of the stove or installation may not be correct.
REMOVE THE PELLETS FROM THE BURNER AND
CONTACT AN AUTHORISED TECHNICIAN.
4.7.2. Extinguishing the stove
The stove can be extinguished at any time and in any position.
To extinguish the stove, press the key
for several seconds.
NEVER SHUT THE STOVE DOWN BY CUTTING OFF THE
ELECTRICITY SUPPLY: Always let it complete the
shutdown cycle, otherwise damage could be caused
to the structure, and also problems with lighting in
the future.
SET
TURBO
1
2
64
3
5
!
18°C
43°C
Stove on and working at full power
To Next Page
Loading...