PELLET STOVES Chapter 4
red
INSTALLATION AND USE MANUAL
page 44
Operation Technical service - Rights reserved - Reproduction prohibited
All automatic relighting operations, either due to a
drop in room temperature or a request for hot water,
are possible if the stove is on or in ECO-STOP mode.
If the user shuts the stove down manually with the
button
, the stove will not relight automatically
upon variation of the temperature or if hot water is
requested
If there is a kit for the production of domestic hot
water, you should disable the ECO-STOP mode in
order to reduce response times when hot water is
requested.
It must be remembered however that the temperature keyed into the
thermostat is only indicative, and it is up to the user to find the correct
setting in the location where the stove is installed (for example, you
need to set 22°C on the thermostat to attain an actual temperature of
20°C). In this mode, the user can light the stove by resetting the
thermostat to a temperature greater than room temperature, or by
pressing for a few seconds on the button
. You will go to "Off" mode,
and then the same button is pressed to relight the stove.
STOVE BEHAVIOUR WITH TIME ACTIVE:
Stove status
Timer intervenes
to…
The stove…
ECO STOP Shut down the stove Shuts down permanently
and turns OFF
ECO STOP Light the stove Remains in ECO STOP
status
4.9.3. Programmed mode (with timer)
This operating mode, shown by the indicator light (9) on the display,
lets you programme stove lighting or extinguishing on a weekly basis.
Normally, the PRIMULA and ORCHIDEA stoves have the
PROGRAMMED mode deactivated. (indicator light 9 is off)
The basic characteristics in PROGRAMMED mode are:
Start day
Clock
Programme (4 daily programmes are available)
4.9.3.1.
Clock (code on display UT 02 and UT 03)
See paragraph 4.5.1. on time setting to find out how to set the current
time.
The following are the main points.
Setting of HOURS (code on display UT 02)
Press the buttons
and to access the setting menu and
parameter “UT 01”. Use the button
to access the parameter
“UT02” which corresponds to the time on the clock expressed in
HOURS.
The display (8) will alternately show the code “UT 02” and the
indication of the internal time of the stove present at that moment.
Figure 8 – Table of correspondence for days of
wee
To Next Page
Loading...