Reely ROAD Rex-X - Disposal

64
 Thepositionoftransmitterandreceiveraerialtoeachotherverystronglyinuencesrange.Itisbestwhenboththe
transmitter and receiver aerial are vertical. If you point the transmitter aerial at the vehicle, the range will be very
short!
• Checkthecorrectpositionofthespeedcontrollerandsteeringservoplugsinthereceiver.Iftheplugsareinserted
rotated by 180°, the speed controller and steering servo will not work.
If, however, the speed controller and steering servo plugs are swapped, the throttle/brake lever controls the steering
servo, and the wheel controls driving!
• Aretheservoandspeedcontrollerplugsconnectedintherightorientation?Atincorrectorientation(iftheplugswere
plugged in twisted by 180°) no control signals reach the speed controller or steering servo from the receiver.
The vehicle does not stop when the throttle/brake lever is released
• Correctthedrivingtrimmingonthetransmitter(settingneutralposition).
• Ifthetrimmingpathisnotsufcient,reprogramtheneutralandfullthrottlepositions;seechapter10a).
• Ifthevehiclehadanaccident,checkthesteeringmechanicsandrepairthem.
The vehicle slows down or the steering servo shows only slight or no reaction; the range between transmitter
and vehicle is very short
• Thedrivebatteriesareweakordischarged.
The receiver power supply and thus also the power supply of the steering servo is achieved through the speed
controller BEC. Therefore, weak or discharged drive batteries will cause the receiver to no longer work properly.
Replace the drive batteries with new, fully charged ones (before inserting a new drive battery, wait at least 5 - 10
minutesuntilmotorandspeedcontrollerhavecooleddownsufciently).
• Checkthebatteries/rechargeablebatteriesinthetransmitter.
The vehicle doesn‘t drive in a straight line correctly
• Setstraightdrivingatthetransmitterusingtherespectivetrimmingcontrolforthesteeringfunction.
• Checkthesteeringrods,theservoarmanditsscrewconnectionsorthewheelalignmentsetting.
• Didyourcarhaveanaccident?Ifso,checkthevehicleforanydefectiveorbrokenpartsandreplacethem.
Steering works opposite to the way the turning wheel is turned at the transmitter
• Activatethesteeringreversesettingatthetransmitter.
Driving works opposite to the movement of the throttle/brake lever at the transmitter
• Usually,thevehicleshoulddriveforwardsifyoupullthethrottle/brakeleveratthetransmittertowardsthehandle.If
this is not the case, activate the reverse setting for the driving function at the transmitter.
The steering is not functioning or is functioning incorrectly, steering deection at the vehicle insufcient
• Ifthetransmitteroffersdualratesettings,checkthesesettings(observetransmitter’soperatinginstructions).Ifthe
dual rate setting is too low, the steering servo will no longer react.
• Checkthesteeringmechanicsforlooseparts;e.g.checkiftheservoarmisproperlyattachedtotheservo.