To Next PageTo Next Page
Need help?Do you have a question about the Reely ROAD Rex-X and is the answer not in the manual?
General safety precautions and important notes for safe operation and handling of the model.
Step-by-step guide for setting up and preparing the vehicle for operation.
Instructions and safety advice for operating the model vehicle during driving.
Procedure for charging the main batteries used to power the vehicle.
Guide for charging the batteries used in the remote control transmitter.
Instructions for safely removing the car body from the chassis.
Guidance on correctly installing the receiver's aerial cable for optimal signal.
Steps for inserting batteries into the remote control transmitter.
Initial setup and checks for operating the transmitter.
Procedure for inserting the vehicle's main drive batteries.
How to connect the vehicle's drive batteries to the speed controller.
Step-by-step guide for powering on the vehicle and transmitter.
How to operate the vehicle using the transmitter controls.
Instructions on how to safely bring the vehicle to a stop.
Explanation of the speed controller's fail-safe mechanism.
Setting the throttle and neutral positions for correct vehicle operation.
Detailed guide on using the programming card to configure the speed controller.
How to adjust the wheel's vertical tilt (camber) for optimal handling.
Adjusting wheel alignment (toe-in/toe-out) for steering response and stability.
Adjusting the spring pre-tension of the shock absorbers.
Instructions for changing the vehicle's wheels.
How to adjust the servo saver for steering protection and accuracy.
General| Scale | 1:10 |
|---|---|
| Drive Type | 4WD |
| Motor Type | Brushed |
| Battery | 7.2V NiMH |
| Model Type | Ready-to-Run (RTR) |
| Terrain | Off-Road |
| Remote Control Frequency | 2.4 GHz |
| Charging Time | 180 min |
| Run Time | 15 min |
| Remote Control Range | 100 meters |
| Material | Plastic and metal |
