6. SERVICE REM - GRAINVAC VR12
6.5. R
EAR & FRONT WEAR WRAPS REPLACEMENT
82 9000-00-0042 R3
Figure 6.8 Tighten Bolt on “Hooked” End of Rear Wear Wrap
6. Using a flat bar and hammer, drive the flat end of the rear wear wrap in as far as
possible to ensure that it fits snugly all the way around the pedestal inner housing
(see Figure 6.9). Insert a new 3/8” x 1-1/2” carriage bolt and secure with 3/8”
whiznut.
Figure 6.9 Flat End of Rear Wear Wrap
7. Remove the counter-sunk bolts retaining the worn front wear wrap in the rotor
housing on the vac body (see Figure 6.10).
To Next Page
Loading...