Respironics BiPAP AVAPS - Page 16

12
User Manual
e information shown on the display screen is defined as follows:
ALARM
Indicates that the device requires user attention as indicated on the screen.
APNEA
Indicates that an apnea alarm has occurred.
AVAPS
Indicates that the device is operating with AVAPS therapy.
BPM
Indicates that a breath rate setting is being displayed. is symbol flashes when the
device is providing timed backup breaths.
CARD
Indicates that a SmartCard is inserted and detected.
cm H
2
O
Indicates that the alphanumeric digits are displaying a pressure value.
CPAP
Indicates that an CPAP pressure setting is being displayed and/or the device is in
CPAP mode.
EPAP
Indicates that an EPAP pressure setting is being displayed.
ERASE
Indicates that the user may clear the erapy Hour Meter.
FLEX
Indicates that the C-Flex/Bi-Flex comfort setting is being displayed or is active.
HEAT
Indicates that the humidifier is turned on and/or its setting is displayed.
HOURS
Indicates that the erapy Hour Meter is being displayed.
IPAP
Indicates that an IPAP pressure setting is being displayed.
IPAP
Max
Indicates that an IPAP maximum pressure setting is being displayed.
IPAP
Min
Indicates that an IPAP minimum pressure setting is being displayed.
LEAK
Indicates that the Estimated Leak Rate is being displayed.
LIGHT
Indicates that the control pad LED backlight setting is being displayed or is active.
LPM
Indicates that the value displayed is in liters per minute.
MinVent
Indicates that the Estimated Minute Ventilation is being displayed.
ml
Indicates that the value displayed is in milliliters.
PATIENT
Indicates that a Patient Disconnect alarm is active or a patient disconnect alarm setting
is being displayed.