Retsch PM100 - Basic Settings; Manual Mode; Grinding Time; Speed

Display and operation
48
6.5.3 Basic settings
You can adjust the following device settings in this settings menu:
– Automatic opening
– Language
– Brightness
– Date
– Time
– Acoustic warning signal
– Service
6.6 Manual Mode
6.6.1 Grinding time
The device is started with the preselected grinding time and at the last speed used. Direction
reversal with pause time has not been switched on
6.6.2 Speed
The device is started with the preselected grinding time and at the last speed used. Direction
reversal with pause time has not been switched on
6.6.3 Interval
The interval time can be set here according to the grinding time. If no interval has been set, no
direction reversal can be set.
6.6.4 Direction reversal
On/off
The device is started with the preselected grinding time, speed and direction reversal. The
machine rotates in one direction for the set interval time, comes to a halt and starts again
immediately in the other direction without a pause time.
6.6.5 Pause time
The pause time between intervals can be set here.
No pause time can be set if no interval has been set.
The device is started with the preselected grinding time, speed, direction reversal and set pause
time. The machine rotates in one direction for the set interval time and comes to a halt; once it
has stopped, the previously set pause time is displayed during the set interval time and counts
down to 00:00:00.
The device starts again in the other direction when the pause time has expired.