Retsch PM100 - Save Parameters; Start in; Programme Mode; Change Program

Display and operation
49
6.6.6 Save parameters
The previously set parameters such as grinding time and speed can be saved in a memory
here.
• Set the desired parameters.
• By turning the control knob (F), switch to the Save parameters menu option.
• Press the control knob (F).
– The Save parameters menu opens and the dark cursor line is on Program.
• Press the control knob (F) to select a program memory location.
• By turning the control knob (F), switch to the desired memory location.
• Press the control knob (F) to exit the memory location selection.
• Select either
- Save to save settings or
- Back to cancel without saving.
6.6.7 Start in
You can set a countdown for starting the device here.
• Press the STOP button to cancel the countdown.
6.7 Programme Mode
6.7.1 Change program
You can change the saved parameters for any program in this menu.
• By turning the control knob (F), switch to the Change program menu option.
• Press the control knob (F).
– The Save parameters menu opens and the dark cursor line is on Program.
NOTICE
You can change the active program or any other program.
• Press the control knob (F) to activate the program selection.
• By turning the control knob (F), switch to the desired memory location.
• Press the control knob (F) to exit the memory location selection.
• Adjust the desired grinding parameters.
• Finally select either
- Save to save settings or
- Back to cancel without saving.
– This takes you back to the Program level.
NOTICE
It is not possible to start a program that has not been saved.
6.7.2 Delete program
You can delete the saved parameters for any program in this menu.
NOTICE
Only the saved parameters for the program concerned are deleted. The program memory
location continues to exist.
• By turning the control knob (F), switch to the Delete program menu option.
• Press the control knob (F).
– The Delete program menu opens and the dark cursor line is on Program.
• Press the control knob (F) to activate the program selection.
• By turning the control knob (F), switch to the desired program.