• Press the control knob (F) to exit the program selection.
• Finally select either
- Delete to delete the settings or
- Back to cancel without deleting.
– This takes you back to the Program level.
6.8 Basic settings
NOTICE
It is not possible to begin grinding while the basic settings menu is active.
6.8.1 Automatic opening
In this menu you can set whether the grinding jar lid opens automatically when grinding ends or
only when the button is pressed.
If the function is switched off, the following pictogram appears on the display as confirmation.
3: Automatic opening pictogram
6.8.2 Language
You can select the menu language here. After selecting and pressing the control knob, the
entire menu structure is displayed in your language.
NOTICE
The language menu is displayed when the device is switched on for the first time.
• Select the desired language by turning the control knob.
– Press to confirm the selection; “open lid” appears on the display.
6.8.3 Brightness
The brightness can be adjusted to suit the respective user or environment (sunshine, glare etc.).
6.8.4 Date
The current date can be entered here.
The device can be disconnected from the mains for up to 30 days before the settings are lost.
6.8.5 Time
The time can be entered here.
The time then appears in the stand-by monitor.
The device can be disconnected from the mains for up to 30 days before the settings are lost.
6.8.6 Acoustic warning signal
Error messages indicating incorrect operation can be supported by an acoustic warning signal.
The corresponding pictogram appears if the function has been switched off
6.8.7 Service
6.8.7.1 Operating hours
Grinding hours are counted, i.e. the total times between START and STOP. It is not possible to
manipulate the times.
6.8.7.2 Software version of display
Shows the software version of the display.
To Next Page
Loading...
