Cleaning, Wear and Maintenance
53
8 Cleaning, Wear and Maintenance
Risk of a fatal electric shock
- An electric shock can cause injuries in the form of burns and cardiac
arrhythmia, respiratory arrest or cardiac arrest.
• Do not clean the blender under running water. Use only a cloth dampened
with water.
• Disconnect the power supply plug before cleaning the blender.
W0012
The device must always be switched off and disconnected from the mains before any
interventions for cleaning or servicing purposes.
8.1 Maintenance
8.1.1 Servicing the closing pin
Fig. 34: Servicing the closing pin
To ensure the operational safety of the equipment, the following servicing work should be
performed from time to time and at least once a month:
• Check the roller (1) on the closing pin to ensure it can move freely, and oil
where necessary, e.g. using sewing machine oil.
• Clean the magnets (2) on the closing pin.
The smooth running of the roller (1) on the closing pin is the prerequisite for the safe closing of
the housing lid.
To Next Page
Loading...
