Grinding jar selection ........................................37
Grinding jar volume ...........................................37
Grinding time ....................................................48
Gripping flanges ................................................39
H
Handling grinding jars .......................................39
Height ...............................................................22
I
Increase of sample volume during grinding
process .........................................................38
Installation ........................................................12
Installation height ........................................ 13, 19
Installation of the device .............................. 13, 19
Installation site
conditions ......................................................13
Interval..............................................................48
IP20 ..................................................................22
L
Latching bracket
wear ..............................................................55
Lid closing.........................................................22
Lid closing mechanism ......................................28
Locking sleeve ..................................................36
LpAeq ...............................................................22
M
Machine type designation..................................20
Mains connection ..............................................21
Mains frequency ...............................................14
Maintenance .....................................................53
Manual mode ....................................................48
Manual operation ..............................................47
Manufacturer’s address .....................................14
Measurement conditions ...................................22
Menu structure ..................................................47
Messages
errors ............................................................52
Moderate or mild injury ........................................8
N
Noise levels ......................................................22
Noise measurement ..........................................22
Nominal volume ................................................37
Notes on the manual ...........................................7
Number of fuses ...............................................14
Number of grinding stations ..............................21
O
Opening aid for the clamping unit ......................35
Operating elements and displays ......................27
Operating hours ................................................50
Operating modes ..............................................47
Operating software version ...............................51
Operating the device .........................................23
Operation .................................................... 16, 44
Overview Table of the Operating Elements and
the Display ....................................................27
Overview table of the parts of the device ...........26
P
Packaging .........................................................12
Part number ......................................................14
Pause time........................................................48
Power ...............................................................37
Power consumption ..........................................21
Power failure ............................................... 29, 37
Power failure during grinding .............................37
Power version ...................................................14
Pressure plate...................................................55
Prising open ......................................................40
Program 01 to 10 .............................................47
Programme mode .............................................49
property damage .................................................8
Protective earth.................................................15
Protective equipment ........................................22
Q
Quantity
ball ................................................................37
R
Rated power .....................................................21
Receptacle volume ...........................................21
Regulations for the place of installation ....... 15, 21
Releasing the grinding jar clamping mechanism 35
Remaining grinding time....................................37
Removing the O-ring .........................................41
Repair ...............................................................10
Replacing the machine fuses ............................55
Required floor space .........................................22
Residual current protection device ....................15
Return
for service and maintenance ..........................57
Return goods dispatch note ..............................57
Rubber washer .................................................55
S
safety closure device.........................................43
Safety notice .....................................................51
Safety warnings ..................................................8
Sample material ................................................37
Sample quantity ................................................37
Sample volumes ...............................................37
Save parameters...............................................49
Selection bar .....................................................45
Serial number ...................................................14
serious injury ......................................................8
Service .............................................................50
Service Address ................................................10
Set language ....................................................50
shielded cable ...................................................15
Sintered corundum............................................37
Software version of display ...............................50
Software version of the controller ......................51
Special steel .....................................................37
Speed ...............................................................48
Stacking the grinding jars ..................................38
Stainless steel...................................................37
Start in ..............................................................49
Suppressor capacitor wiring ..............................15
To Next Page
Loading...
