REXROTH EFC 3610 Series - Page 4

Page
3.3.1 Checking before Power-on................................................................... 33
3.3.2 Checking after Power-on...................................................................... 33
3.3.3 Checking Start-up Parameters............................................................. 33
3.3.4 Control the Motor................................................................................ 35
3.3.5 Motor Parameters Auto-Tuning............................................................. 36
3.4 Parameter List..................................................................................... 39
3.4.1 Terminology and Abbreviation in Parameter List................................. 39
3.4.2 Group b: System Parameters............................................................... 40
b0: Basic system parameters............................................................... 40
3.4.3 Group C: Power Parameters................................................................ 41
C0: Power control parameters............................................................. 41
C1: Motor and system parameters....................................................... 43
C2: V/f control parameters.................................................................. 45
C3*: Vector control parameters........................................................... 47
3.4.4 Group E: Function Control Parameters................................................ 49
E0: Set point and control parameters.................................................. 49
E1: Input terminal parameters............................................................. 52
E2: Output terminal parameters.......................................................... 55
E3: Multi-speed and simple PLC parameters....................................... 58
E4: PID control parameters.................................................................. 61
E5: Extended function parameters....................................................... 62
E8: Standard communication parameters............................................ 63
E9: Protection and error parameters................................................... 64
3.4.5 Group F0: ASF Parameters.................................................................. 66
3.4.6 Group H: Extension Card Parameters.................................................. 67
H0: Extension card general parameters............................................... 67
H1: Communication card parameters.................................................. 68
H8: I/O card parameters...................................................................... 71
H9: Relay card parameters................................................................... 76
3.4.7 Group U: Panel Parameters.................................................................. 78
U0: General panel parameters............................................................. 78
U1: LED panel parameters................................................................... 78
U2: LCD panel parameters................................................................... 79
3.4.8 Group d0: Monitoring Parameters....................................................... 81
4 Diagnosis............................................................................................. 83
4.1 Display of LED Characters................................................................... 83
4.2 Status Code......................................................................................... 83
Bosch Rexroth AG
Table of Contents
EFC 3610 / EFC 5610
II
DOK-RCON03-EFC-X610***-QU11-EN-P