37: Forward jog
38: Reverse jog
39: Counter input
40: Counter reset
41: PID deactivation
46: User parameter set selection
48: Motor overheating error N.O. contact input
49: Motor overheating error N.C. contact input
50: Motor overheating warning N.O. contact input
51: Motor overheating warning N.C. contact input
Setting range of H8.06:
0: Polarity inactive
1: Polarity active without direction control
2: Polarity active with direction control
Setting range of H8.20, H8.21, H8.22:
0: Converter ready
1: Converter running
2: Converter DC-braking
3: Converter running at zero speed
4: Speed arrival
5: Frequency level detection signal (FDT1)
6: Frequency level detection signal (FDT2)
7: Simple PLC stage complete
8: Simple PLC cycle complete
10: Converter undervoltage
11: Converter overload pre-warning
12: Motor overload pre-warning
13: Converter stop by external error
14: Converter error
15: Converter OK
16: Counter target value arrival
17: Counter middle value arrival
18: PID reference engineering value arrival
20: Torque control mode
21: Parameter setting from communication
①
25: Converter error or warning
Bosch Rexroth AG
Start-up
EFC 3610 / EFC 5610
74/87
DOK-RCON03-EFC-X610***-QU11-EN-P
To Next Page
Loading...
Need help?
General
