REXROTH VFC 3610 - Page 4

Page
3.2.1 LCD Panel Introduction........................................................................ 33
3.2.2 Operating Example.............................................................................. 34
3.3 Start-up Procedure.............................................................................. 35
3.3.1 Checking before Power-on................................................................... 35
3.3.2 Checking after Power-on...................................................................... 35
3.3.3 Checking Start-up Parameters............................................................. 35
3.3.4 Control the Motor................................................................................ 37
3.3.5 Motor Parameters Auto-Tuning............................................................. 38
3.4 Parameter List..................................................................................... 39
3.4.1 Terminology and Abbreviation in Parameter List................................. 39
3.4.2 Group b: System Parameters............................................................... 40
b0: Basic system parameters............................................................... 40
3.4.3 Group C: Power Parameters................................................................ 41
C0: Power control parameters............................................................. 41
C1: Motor and system parameters....................................................... 44
C2: V/f control parameters.................................................................. 46
C3*: Vector control parameters........................................................... 48
3.4.4 Group E: Function Control Parameters................................................ 51
E0: Set point and control parameters.................................................. 51
E1: Input terminal parameters............................................................. 54
E2: Output terminal parameters.......................................................... 57
E3: Multi-speed and simple PLC parameters....................................... 60
E4: PID control parameters.................................................................. 63
E5: Extended function parameters....................................................... 64
E8: Standard communication parameters............................................ 65
E9: Protection and error parameters................................................... 66
3.4.5 Group F0: ASF Parameters.................................................................. 69
3.4.6 Group H: Extension Card Parameters.................................................. 70
H0: Extension card general parameters............................................... 70
H1: Communication card parameters.................................................. 71
H8: I/O card parameters...................................................................... 74
H9: Relay card parameters................................................................... 79
3.4.7 Group U: Panel Parameters.................................................................. 81
U0: General panel parameters............................................................. 81
U1: Seven-segment panel parameters................................................. 81
U2: LCD panel parameters................................................................... 82
3.4.8 Group d0: Monitoring Parameters....................................................... 84
II
Table of Contents
Rexroth Frequency Converter VFC
3610 / VFC 5610
Bosch Rexroth AG R912005518_Edition 16