Reymsa RT-1616 - User Manual

The
All-Fiberglass
Cooling Towers
Installation, Operation & Maintenance Manual
RT, RTU, RTG, RTM & RTGM Models
Standard & Low Sound Fans
RT
Series

Summary

Installation Procedures

A.1.2 ENVIRONMENTAL AND SAFETY

Standards and safety measures for tower installation and placement.

A.2 ASSEMBLY INSTRUCTIONS FOR RT MODELS

Step-by-step guide for assembling RT model cooling towers.

A.2.1 SINGLE FAN TOWERS

Assembly instructions for RT single fan cooling towers.

A.2.2 DOUBLE FAN TOWERS

Assembly instructions for RT double fan cooling towers.

A.2.3 QUADRUPLE FAN TOWERS

Assembly instructions for RT quadruple fan cooling towers.

A.3 ASSEMBLY INSTRUCTIONS FOR RTU MODELS

Assembly instructions for RTU model cooling towers.

A.3.1 SINGLE FAN TOWERS (RTU)

Assembly instructions for RTU single fan cooling towers.

A.3.2 DOUBLE FAN TOWERS (RTU)

Assembly instructions for RTU double fan cooling towers.

A.3.3 QUADRUPLE FAN TOWERS (RTU)

Assembly instructions for RTU quadruple fan cooling towers.

A.4 ASSEMBLY INSTRUCTIONS FOR RTG MODELS

Procedures for assembling RTG model cooling towers.

A.5 ASSEMBLY INSTRUCTIONS FOR MODULAR TOWERS (RTM)

General steps for assembling RTM modular cooling towers.

A.5.1 GENERAL PROCEDURE

General steps for assembling RTM modular cooling towers.

A.6 ASSEMBLY INSTRUCTIONS FOR MODULAR TOWERS (RTGM)

General assembly procedure for RTGM modular cooling towers.

A.6.1 GENERAL PROCEDURE

General assembly procedure for RTGM modular cooling towers.

A.10.2 VIBRATION SWITCH

Installation and adjustment of vibration switches for motor protection.

A.10.3 BASIN HEATER

A.10.4 ELECTRIC WATER LEVEL CONTROL SYSTEM

A.10.5 MOTOR SHAFT GROUNDING RING

A.11 TOWER SET-UP

Procedures for setting up the cooling tower, including leveling and wiring.

A.11.1 LEVELING AND TOWER SUPPORTS

Guidelines for proper tower leveling and structural base support.

A.11.2 PIPING CONNECTIONS

A.11.3 WIRING

A.11.3.1 PROCEDURE TO WIRE THE FAN MOTOR

Step-by-step procedure for wiring the fan motor.

Start-Up Procedures

Operation Guidelines

C.1 FAN CONTROL - VFD

C.5 COLD WEATHER OPERATION

Maintenance

D.1 TOWER MAINTENANCE SCHEDULE

D.4 FAN MOTOR

D.5 GEAR REDUCER

D.6 BASIN HEATER

Trouble-Shooting

Exiting water temperature is too high

Unusual noises when the Tower is operating

Pump cavitation

Low cold water flow rate

The water is not falling uniformly from the fill

Water leaking around the access door

Water leaking from a crack in the fiberglass

Water leaking through the air inlet louvers

Excessive Drift

Excessive accumulation of debris or dirt in the bottom of the basin

Unusual noise or vibration in the Gear Reducer (RTG & RTGM)

Reymsa RT-1616 Specifications

General

Brand	Reymsa
Model	RT-1616
Category	Fan
Language	English