5. System Setup and Operation
How to Realize Single Image Switching
CP 3072 User Manual 50
How to Realize Single Image Switching
CP 3072 can realize seamless effects switch between two channels,
choose the channel in B-BUS/PST area, then push the [TAKE] button, the
signal will be switched to LED display.
For example, switch channel 2 to LED display, first push the [2] button in
B-BUS/PST area, then push the [TAKE] button or T-bar in T-bar control
area, and the LED display will show the signal of channel 2.
System default the switch time is 1 second for [TAKE] button, if need to
adjust the fade time, turn the knob in transition time control area, and set
according to actual need, push the [TAKE] button again, the signal will be
switched to the LED display with the adjusted time.
To Next Page
Loading...
Need help?
General