RichAuto S & T Co., Ltd
Add: 5th
floor, No.4 building, No 4. Yard, life Rd, life science park, beiqing St., changping district Beijing, China
Tel：010-53275118 Fax：010-53275110/53275111 Web site：www.richnc.com.cn
46
Press “ ”、“ ” to move the cursor and choose, press “ ” to
enter into the list, the screen will display three file name, choose the file by pressing
“ ”、“ ”. Press “ ”、“ ” to turn to the next page. Press
“ ” to exit.
5.4.3 Processing parameters setting
After choosing the processing file please press“ ”,enter into processing
parameters seeting, it includes work speed、travel speed（or Fast speed）、 speed
scale(speed ratio)、fall down speed(or Z down ratio).
Press “ ” and “ ” to move cursor, press “ ” to set the value
(next value setting is the same as this one), then pess “ ” to save, the system
will check the processing code and start to process when checking finished.
The system code checking is auto mode, user can press “ ” to skip the
checking and start ruuning file immidiately.
System will remenber the checking only when the previous checking is a
complete and correct checking.So that the system will not check the same code
again next time.
Set Work Param
WorkSpd 3000.000
FastSpd 3000.000
SpdScale 1.000
FallDown 0.200
To Next Page
