RichAuto A11 - 5.4 Automatic processing operation

RichAuto S & T Co., Ltd
Add: 5th floor, No.4 building, No 4. Yard, life Rd, life science park, beiqing St., changping district Beijing, China
Tel：010-53275118 Fax：010-53275110/53275111 Web site：www.richnc.com.cn
44
remove all abnormal states ，you need back to zero.
Work coordinate system used more greatly than other coordinates system in
processing.Usually in processing, we describe a processing position is always relative
to a certain point on the workpiece, whereas the workpiece on the machine tool's
position relative to the mechanical origin is often change, so it is necessary to
introduce a set of more convenient coordinate system during processing, this is work
coordinate system.The origin of work coordinate system is a fixed point relative to the
workpiece, but relative to the origin of machine coordinate system is floating.
RichAuto-A11 provide a machine coordinate system and eight work
coordinates system，press“ ”+“ ”can switch machine coordinate system
and work coordinate system，“ ”+“NO.button1-8”can switch machine
coordinate system and eight work coordinates system.
Coordinates system：
Machine coordinate system Work coordinate system1
…
Work coordinate system2 … Work coordinate system8
NOTE：You can not set work origin under machine coordinate system，switch to work
coordinate system to set work origin.
 5.4 Automatic processing operation
Auto processing refers to the system runs the file in U disk or inner storage
AX 0.000 MAUN
AY 0.000 S 2
AZ 0.000 L SP
Continous
1X 0.000 MAUN
1Y 0.000 S 2
1Z 0.000 L SP
Continous
2X 0.000 MAUN
2Y 0.000 S 2
2Z 0.000 L SP
Continous
8X 0.000 MAUN
8Y 0.000 S 2
8Z 0.000 L SP
Continous