Message Problem and solutions
Updated (option name)(value) via DHCPv6 Server The parameter obtained from the DHCP server has
been updated.
WINS name registration: No response to server
(WINS server address)
There was no response from the WINS server.
Check that the correct WINS server address is
entered. Also, check that the WINS server is
functioning properly.
WINS wrong scope ID=<scope ID> The scope ID is invalid. Use a valid scope ID.
write error occurred. (diskfull) A “diskfull” error occurred while the machine was
writing to the spool file. Wait for the current print
job to finish, When it finishes, more HDD space will
be available. Only pages that were spooled when
the error occurred will be printed.
write error occurred. (fatal) A fatal error occurred while the printer was writing
to the spool file. Turn off the power of the printer,
and then turn it on again. If the error recurs, contact
your service representative. The print job that was
being spooled when the error occurred will not be
printed.
WSD (Device) started. WS-Device has started.
WSD (Printer) started. WS-Printer has started.
WSD (Scanner) started. WS-Scanner has started.
#[nfa (process ID)] <time date> + Failed to send
logos to a log collection server <IP address>.
An error occurred while trying to send a log file to
both the primary and secondary log collection
servers.
#[nfa (process ID)] <time date> + Failed to send
logs to a collection server <IP address> n time(s) in
1 hour.
60 minutes has passed since the last log entry.
During that time, an error occurred while trying to
send the log file to both the primary and secondary
log collection servers.
• For details about UNIX commands and parameters, see UNIX Supplement.
Message List
223
To Next Page
Loading...
