9. Select [Folder Info] using [ ] or [ ], and then press the [OK] key.
10. Select [SMB] using [ ] or [ ], and then press the [OK] key.
11. Select [Manual Entry] or [Browse Network] using [ ] or [ ], and then press the [OK] key.
To specify a folder, you can either enter the path manually or locate the folder by browsing the
network. See "Locating the folder manually" and "Locating the folder using Browse Network".
12. Specify the folder.
13. Press [Com.Test] to check the path is set correctly.
14. Press [Exit].
Registering Folders
291
To Next Page
Loading...
