• When [Do not Specify] is selected, the NCP User Name and NCP Password that you have specified
in Default User Name/Password (Send) of File Transfer settings applies.
• If User Authentication is specified, contact your administrator.
• p.36 "File Transfer"
• p.230 "Registering Names"
Locating the NCP folder manually
This section describes how to locate the SMB folder manually.
1. Select [Manual Entry] using [ ] or [ ], and then press the [OK] key.
2. Enter the path and then press the [OK] key.
• If you set "Connection Type" to [NDS], and if the NDS tree name is "tree", the name of the context
including the volume is "context", the volume name is "volume" and the folder name is "folder", then
the path will be "\\tree\volume. context\folder".
• If you set "Connection Type" to [Bindery], and if the NetWare server name is "server", the volume
name is "volume" and the folder name is "folder", then the path will be "\\server\volume\folder".
• You can enter a path using up to 256 characters.
• If the connection test fails, check the settings, and then try again.
Locating the NCP folder using browse network
This section describes how to locate the NCP folder using Browse Network.
Registering Folders
311
To Next Page
Loading...
