Common Procedures
SM 1 D372
500-Sheet
Finisher
D372
1. REPLACEMENT AND ADJUSTMENT
1.1 COMMON PROCEDURES
1.1.1 DISCONNECTING, REMOVING THE FINISHER
The finisher must be removed from the machine for these procedures. The front
and rear covers cannot be removed while the finisher is attached to the side of the
machine.
1. Disconnect the finisher I/F cable [A] on the left side of the machine.
2. Remove the lock plate [B] ( x1).
3. Press the spring release [C] toward the rear of the finisher, then lift the finisher off its
center post.
To Next Page
Loading...
