HDD Encryption Unit
D017/D018/D019/D020 1-76 SM
12. Remove the SD card from slot 2.
13. Reinstall the HDD unit.
Clearing the NVRAM
When replacing the controller board for a model in which the HDD encryption unit has been
installed and a customer has lost the encryption key, clearing the NVRAM is required to
recover the HDD encryption unit.
1. Prepare an SD card which is initialized.
2. Make the "restore_key" folder in the SD card.
3. Make an "nvram_key.txt" file in the "restore_key" folder in the SD card.
4. Input "nvclear" into the "nvram_key.txt" file.
5. Turn on the main power switch.
6. Confirm that the prompt on the LCD tells you to install the SD card (storing the
encryption key) in the machine.
7. Turn off the main power switch.
8. Insert the SD card that contains “nvclear” into slot 2.
9. Turn on the main power switch, and the machine automatically restores the encryption
key in the flash memory on the controller board.
10. Turn off the main power switch after the machine has returned to normal status.
11. Remove the SD card from slot 2.
12. Turn on the main power switch.
13. Initialize the NVRAM (SP5801-001) and HDD unit (SP5832-001) with SP mode.
14. The user must enable the HDD encryption unit with a user tool.
1.20.3 MORE ABOUT HDD ENCRYPTION UNIT (D377)
Overview
The HDD Encryption unit encodes user data and machine settings to prevent this data from
being stolen if somebody steals the hard disk. To activate this unit, an administrator must
enable the unit with the user mode after installation by a customer engineer. Also, if
"Administrator Authentication Management" is not turned on, this function is not displayed
in the menu on the LCD.
Encrypted Data
The data to be encrypted are shown below:
User Data in the HDD
To Next Page
Loading...
