Data Overwrite Security Unit (D362-11)
SM 1-79 D017/D018/D019/D020
Installation
1.21 DATA OVERWRITE SECURITY UNIT (D362-11)
1.21.1 ACCESSORY CHECK
Check the accessories and their quantities against the table below.
Description Q’ty
1. Data Overwrite Security SD Card
1
2. Operating Instructions CD-ROM 1
3. Comments Sheet (17 languages) 2
1.21.2 BEFORE YOU BEGIN
1. Confirm that the Data Overwrite Security unit SD card is the correct type for the
machine. The correct type for this machine is "Type I".
2. Make sure that the following features have been set up:
Supervisor login password
Administrator login name
Administrator login password
These settings must be set up by the customer before the DOS option can be
installed.
3. Confirm that "Admin. Authentication" is on:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Admin. Authentication"> "On"
If this setting is "Off" tell the customer that this setting must be "On" before you can do
the installation procedure.
4. Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Available Settings
If this setting is not selected tell the customer that this setting must be selected before
you can do the installation procedure.
"Available Settings" is not displayed until Step 2 has been done.
⇒
Rev. 02/2008
To Next Page
Loading...
