Copy Data Security Unit (B829)
D017/D018/D019/D020 1-70 SM
FCU faceplate ( x3)
Controller board unit ( x3)
2. Remove these parts: (see section 3.10.4)
Paper tray unit connector cover ( x1)
Disconnect the paper tray unit or LCT (if it is installed) ( x1)
Rear cover ( x1).
3. Pull the controller board partially out of the left slot to disconnect it from the IPU.
4. Remove the IPU [A] from the main machine.
The board for this option is installed on the back of the IPU board.
5. Attach the harness clamp [B].
6. Attach the ICIB [C] ( x4)
To Next Page
Loading...
