Copy Adjustments: Printing/Scanning
D017/D018/D019/D020 3-68 SM
2. On the touch screen press “Touch Screen Adjust” (or press on the ten-key pad).
3. Use a pointed (not sharp!) tool to press the mark at the upper left of the screen ()).
4. Press the mark at the lower right of the screen (*) after it appears.
5. Touch a few spots on the touch panel to confirm that the marker (+) appears exactly
where the screen is touched.
If the + mark does not appear where the screen is touched, press Cancel and
repeat from Step 2.
6. When you are finished, press [#] OK on the screen (or press on the ten-key pad).
7. Touch [#] Exit on the screen to close the Self-Diagnostic menu and save the calibration
settings.
To Next Page
Loading...
