Service Call Conditions
D017/D018/D019/D020 4-6 SM
IPU defective
BCU defective
SBU defective
IPU Error
161 D
The self-diagnostic test detected an
error at the IPU at power on, or after
the machine returned from energy
save mode.
Harness between SBU and
IPU loose or broken
IPU defective
SBU defective
Copy Data Security Unit error
165 B
An error occurred when the machine
attempted to recognize the Copy Data
Security Unit board.
Check installation of Copy
Data Security (CDS) Unit
CDS unit not correct type for
the machine
CDS unit defective
Polygon motor error 1: ON timeout
202 D
The polygon mirror motor did not reach the targeted operating speed within
10 sec. after turning on or changing speed
Polygon motor error 1: OFF timeout
203 D
The polygon mirror motor did not leave READY status within 3 sec. after
polygon motor switched off.
Polygon motor error 1: XSCRDY signal error
204 D
The XSCRDY signal remained HIGH for 200 ms while the LD unit was
firing.
Polygon motor/driver board harness loose or broken
Polygon motor/driver board defective
Laser optic unit defective
IPU defective
To Next Page
Loading...
