SP1xxx: Feed
D017/D018/D019/D020 5-14 SM
3 Duplex Side 2 [0 to 20 / 6 / 1 mm/step]
By-pass Paper Size Detection
1007*
Controls paper size detection for the by-pass feed table.
1 Detection Timing
[-15 to 15 / 0 / 5 mm step]
2 LG Detection
[0 to 1 / 0 / -]
0: LT SEF, 1: LG
Fusing Idling
1103
Switches fusing idling on/off.
[0 = Off / 1 = On / 2 = Off plus machine temperature check]
Switch on if fusing on the 1st and 2nd copies is incomplete (this may occur if
the room is cold.)
Fusing Temperature Control DFU
1104
[0 to 1/1/1]
0: Hysterysis Control
1: Normal Control
1105* Fusing Temperature Adjustment
1 Roller Center
2 Roller Ends
Adjusts the fusing temperature at the
center and both ends of the hot roller for
normal printing.
[120 to 200 / 180 / 1°C/step]
3 Energy Saver
Adjusts the fusing temperature at the
center and both ends of the hot roller for
energy saver mode.
[0 to 160 / 150 / 1°C/step]
4 Thick Paper – Roller Center Adjusts the additional fusing temperature
To Next Page
Loading...
