SP2xxx: Drum
D017/D018/D019/D020 5-26 SM
If the user normally makes copies with a high proportion of black, reduce the
interval.
2220* Vsg/V/Vsdp/Vt/Vts Display
1 Vsg
2 V
3 Vsdp
4 Vt
5 Vts
Displays the individual Vt, Vsg, Vsp, Vsdp, and Vts
values.
6 Vsp/Vsg/Vsdp/Vt/Vts
Displays all the data used in process control,
separated by slashes (/).
2301* Transfer Current Adjust
Normal Paper
1*
Adjusts the current applied to the transfer roller during copying from a paper
tray when the user uses the “Normal” paper setting.
If the user normally feeds thicker paper from a paper tray, use a higher
setting.
[0 = –2 μA / 1 = 0 μA / 2 = +2 μA / 3 = +4μA]
Thick/Thin Paper
2*
Adjusts the current applied to the transfer roller during copying from the
by-pass tray. These settings are also used if the 2nd tray is used and special
paper is selected.
If the user normally feeds thicker paper from the by-pass tray/2nd tray
(special paper), use a higher setting. If waste toner is re-attracted from the
drum (this can occur when using an OHP sheet), use a higher setting.
[0 = –2 μA / 1 = 0 μA / 2 = +2 μA / 3 = +4μA]
3* Duplex Side 2
To Next Page
Loading...
