SP2xxx: Drum
SM 5-31 D017/D018/D019/D020
Service
Tables
Forces the toner bottle to supply toner to the toner supply unit.
Press Execute on the touch panel to start.
During this process, the machine supplies toner until the toner concentration
in the development unit reaches a standard level. However, if the toner
concentration does not reach a standard level, the machine supplies toner
for 2 minutes maximum.
Main Scan Magnification Adj
2909*
[-0.5 to 0.5 / 0.0 / 0.1%/step]
Copy: Short Edge Feed
1
Adjusts the main scan magnification in copy mode when the machine feeds
the paper in the short edge feed orientation.
Printer: Short Edge Feed
2
Adjusts the main scan magnification in printer mode when the machine
feeds the paper in the short edge feed orientation.
Copy: Long Edge Feed
3
Adjusts the main scan magnification in copy mode when the machine feeds
the paper in the long edge feed orientation.
Printer: Long Edge Feed
4
Adjusts the main scan magnification in printer mode when the machine
feeds the paper in the long edge feed orientation.
Margin Adjust for By-pass
2910*
Adjusts the blank margin at the trailing edge of paper fed from the by-pass
table.
[-9.0 to +9.0 / 0 mm / 0.1 mm/step]
2913* ID Test Pattern
To Next Page
Loading...
