SP2xxx: Drum
SM 5-37 D017/D018/D019/D020
Service
Tables
ISSUER CODE Ref South Korea Only
2993*
Sets the standard issuer code, once it has been determined.
[0 to 9999 / 0 / 1]
2994* Vts Limitation - Factory
1 Upper Limit - Factory Only
DFU
2 Lower Limit - Factory Only
DFU
2995* ID Sensor Detection Interval
Warming-up
1
This SP controls the temperature at which the ID sensor pattern is created
after the machine is turned on, or after the machine returns to full operation
from the energy saver or auto off mode.
[0 to 255 / 30 / 1 degree]
Number of Pages
2
The machine makes an ID sensor pattern after the specified number of
prints has been made.
[0 to 999 / 300 / 1 page/step]
3 Job End/Interrupt
Determines when the ID sensor reads the ID sensor pattern.
0: Job End. Read pattern at job end.
1: Interrupt. Read pattern at interval set with SP2995-2, even if the job is not
completed.
Transfer Roller Cleaning
2996
These SP codes determine how the transfer roller is cleaned.
1 0:OFF 1:ON
To Next Page
Loading...
