Bit Switches
D361 98 SM
Communication Switch 14 (SP No. 1-104-021)
No Function Comments
transmission
0: Disabled, 1: Enabled
scanned in inch format are transmitted
without conversion.
In memory transmission, data stored in
the SAF memory in mm format are
transmitted without conversion.
Note: When storing the scanned data
into SAF memory, the fax unit always
converts the data into mm format.
1: The machine converts the scanned
data or stored data in the SAF memory
to the format which was specified in the
set-up protocol (DIS/NSF) before
transmission.
1-5 Not used Do not change the factory settings.
Available unit of resolution in which fax
messages are received
Bit 7 Bit 6 Unit
0 0 mm
0 1 inch
1 0 mm and inch
6-7
1 1 Not used
For the best performance, do not change
the factory settings.
The setting determined by these bits is
informed to the transmitting terminal in
the pre-message protocol exchange (in
the DIS/NSF frames).
Communication Switch 15 – Not used (do not change the settings)
To Next Page
Loading...
