Message Cause Solution
"Magazine or Booklet mode
is not available due to mixed
image mode."
You selected the "Magazine"
or "Booklet" function for
originals scanned using
different functions, such as
copy and printer.
Make sure originals for the "Magazine"
or "Booklet" function are scanned using
the same function.
"Maximum number of sets is
n."
(A figure is placed at n.)
The number of copies
exceeds the maximum copy
quantity.
You can change the maximum copy
quantity from [Max. Copy Quantity] in
[General Features] under [Copier /
Document Server Features]. For details
about Max. Copy Quantity, see
"General Features", Copy and
Document Server Reference .
"Original is being scanned by
another function. Switch to
the following function, then
press the Stop key to cancel
scanning or press the Start
key to continue."
A function of the machine
other than the Copier function
is being used such as the
Document Server function.
Cancel the job in progress. For example,
press [Exit], and then press the
[Document Server] key. Next, press the
[Clear/Stop] key. When the message
"The Clear / Stop key was pressed. Are
you sure you want to stop scanning?"
appears, press [Stop].
"Please wait." The destination list is being
updated from the network
using SmartDeviceMonitor
for Admin. Depending on the
number of destinations to be
updated, there may be some
delay before you can resume
operation. Operations are
not possible while this
message is displayed.
Wait until the message disappears. Do
not switch off the power while this
message is displayed.
"Rotate Sort is not available
with this paper size."
A size of paper for which
Rotate Sort is not available is
selected.
Select a proper paper size. See "Sort",
Copy and Document Server Reference
.
"Stapling capacity
exceeded."
The number of sheets per set
is over the staple capacity.
Check the stapler capacity. See
"Appendix", About This Machine .
Messages Displayed When Using the Copy/Document Server Function
29
To Next Page
Loading...
Need help?
General
