Problem Cause Solution
In "Erase Border", "Erase
Centre", or "Erase Centre /
Border" mode, parts of the
original image are not
copied.
Originals are not scanned
correctly.
Place the originals correctly.
In "Margin Adjustment"
mode, parts of the original
image are not copied.
• You set a wide erased
margin.
• There is a lack of margin
space on the opposite
side of the binding
position.
Set a narrower margin with User Tools.
You can set the width between 0 - 30
mm (0 - 1.2 inches).
In "Image Repeat" mode, the
original image is not copied
repeatedly.
You selected copy paper the
same size as the originals, or
you did not select the proper
reproduction ratio.
Select copy paper larger than the
originals or select the proper
reproduction ratio.
Stamp
Problem Cause Solution
The stamp position is wrong. The paper orientation is
wrong.
Check the paper orientation and stamp
position.
The stamp is not printed on the
back side of sheets when
duplex copying.
The back side stamp position
is incorrect for the paper size.
Reset the back side stamp position. For
details about Duplex Back Page
Stamping Position, see "Copier /
Document Server Features", Copy and
Document Server Reference .
Combine
Problem Cause Solution
Copies made with the
"Booklet" or "Magazine"
function cannot be folded into
a book correctly.
You selected a setting ("Open
to Left" or "Open to Right")
that does not match the
orientation of originals.
In [Copier / Document Server Features],
under [Edit], set [Orientation: Booklet,
Magazine] properly.
When You Cannot Make Copies As Wanted
39
To Next Page
Loading...
Need help?
General
