Monitoring and Configuring the Printer
94
2
Getting Printer Information over the Network
This section explains details of each item displayed in the printer status and in-
formation.
This manual covers all models, and therefore contains functions and settings
that may not be available for your model.
Current Printer Status
The printer status can be checked using the following commands:
• UNIX: Use the "lpq" command and "rsh", "rcp", “ftp”, and "sftp" parameters.
• mshell: Use the "status" command.
Messages Description
Access Restricted The job was canceled because user have no authority.
Adjusting... The machine is initializing or calibrating.
Call Service Center There is a malfunction in the machine.
Canceled The job is reset.
Canceling Job... The job is being reset.
Cannot Eject Original Through Cannot output prints to the Rear Paper Exit.
Card/Counter not inserted The machine is waiting for prepaid card or key.
Coin or amount not inserted The machine is waiting for coin to be inserted.
Coin/Key Counter not inserted The machine is waiting for coin or key counter.
Configuring... Setting is being changed.
Cooling Down Fusing Unit... The fusing unit is cooling down.
Cover Open: Finisher Cover The cover of Finisher is open.
Data Size Error The data size error occurred.
Empty: Black Toner The black toner cartridge is almost empty.
Energy Saver Mode The machine is in Energy Save Mode.
Error An error has occurred.
Error: Address Book An error has occurred in the data of the address book.
Error: Command Transmission An error has occurred in the machine.
Error: DIMM Value A memory error occurred.
Error: Ethernet Board An Ethernet board error has occurred.
Error: HDD Board A hard disk drive board error has occurred.
Error: Memory Switch A memory switch error has occurred.
Error: Optional Font An error has occurred in the font file of the machine.
Error: Parallel I/F Board An error has occurred in the parallel interface.
To Next Page
Loading...
