Monitoring and Configuring the Printer
40
2
Installing SmartDeviceMonitor for Admin
Follow the procedure below to install SmartDeviceMonitor for Admin
A Quit all applications currently running.
B Insert the CD-ROM into the CD-ROM drive.
The installer starts.
C Select an interface language, and then click [OK].
The following languages are available: Czech, Danish, German, English,
Spanish, French, Italian, Hungarian, Dutch, Norwegian, Polish, Portuguese ,
Finnish, Swedish, Chinese Simple and Chinese Traditional.
D Click [SmartDeviceMonitor for Admin].
E Click [Next >].
The software license agreement appears in the [License Agreement] dialog box.
F After reading through its contents, click [Next >].
G Follow the instructions on the screen.
A message appears when the installation is completed.
H Click [OK].
A message about restarting the computer may appear. Restart the computer
to complete installation.
Note
❒ Auto Run may not work under certain operating system settings. In this
case, launch “Setup.exe” located on the CD-ROM root directory.
❒ If you are required to restart the computer after installing SmartDevice-
Monitor for Admin, restart the computer and continue the configuration.
To Next Page
Loading...
