Using NetWare
23
1
Setting Up as a Remote Printer (NetWare 3.x)
Follow the procedure below to use the machine as a remote printer under Net-
Ware 3.x.
Setting up using PCONSOLE
A Enter “PCONSOLE” from the command prompt.
F:> PCONSOLE
B Create a print queue.
When using the existing print queue, go to the procedure for creating a printer.
C From the [Available Options] menu, select [Print Queue Information], and then
press the {Enter} key.
D Press the {Insert} key, and then enter a print queue name.
E Press the {Esc} key to return to the [Available Options] menu.
F Set up the network connection to a printer.
G On the [Available Options] menu, click [Print Server Information], and then press
the {Enter} key.
H To create a new print server, press the {Insert} key, and then enter a print
server name.
For a currently defined print server, select a print server in the [Print Server] list.
Use the same printer name specified using NIB Setup Tool.
I From the [Print Server Information] menu, select [Print Server Configuration].
J From the [Print Server Configuration] menu, select [Printer Configuration].
K Select the printer indicated as [Not Installed].
Use the same printer number specified as the remote printer number using
NIB Setup Tool.
L To change the printer name, enter a new name.
A name “printer x” is assigned to the printer. The “x” stands for the number
of the selected printer.
M As type, select [Remote Parallel, LPT1].
The IRQ, Buffer size, Starting form, and Queue service mode are automatically
configured.
N Press the {Esc} key, and then click [Yes] on the confirmation message.
O Press the {Esc} key to return to [Print Server Configuration Menu].
P Assign print queues to the created printer.
Q From [Print Server Configuration Menu], select [Queues Serviced By Printer].
To Next Page
Loading...
