Monitoring and Configuring the Printer
88
2
web
Use the “web” command to display and configure parameters on Web Image Monitor.
❖ View Settings
msh> web
❖ URL Configuration
You can set URLs linked by clicking [URL] on Web Image Monitor.
Specify "1" or "2" for x as the number corresponding to the URL. Up to two
URLs can be registered and specified.
msh> web url http://”The URL or IP address you want to
register”/
❖ Resetting URLs registered as link destinations
msh> web x clear url
Specify "1" or "2" for x as the corresponding number to the URL.
❖ Link name configuration
You can enter the name for URL that appears on Web Image Monitor.
Specify "1" or "2" for x as the corresponding number to the link name.
msh> web name “Name you want to display”
❖ Resetting URL names registered as link destinations
msh> web x clear name
Specify "1" or "2" for x as the number corresponding to the link name.
❖ Help URL Configuration
You can set URLs linked by clicking [Help] or [?] on Web Image Monitor.
msh> web help http://”Help URL or IP address”/help/
❖ Resetting Help URL
msh> web clear help
To Next Page
Loading...
