Remote Maintenance by telnet
71
2
help
Use the "help" command to display the available command list and the procedures
for using those commands.
❖ Command list display
msh> help
❖ Display of procedure for using commands
msh> help “command_name”
hostname
Use the “hostname” command to change the printer name.
❖ View settings
msh> hostname
❖ IPv4 Configuration
msh> hostname “interface_name ” “printer_name”
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name beginning “RNP” (in either upper or lower
case).
• The Ethernet interface and IEEE 802.11b interface will have the same printer
name.
• wlan can be specified only when the IEEE 802.11b interface is installed.
❖ Initializing the printer name for each interface
msh>hostname “interface_name” clear name
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11b interface
To Next Page
Loading...
