Ricoh Aficio MP W3600 - Configuring the Energy Save Mode

Using SmartDeviceMonitor for Admin
47
2
Configuring the Energy Save Mode
Follow the procedure below to configure Energy Save Mode.
A Start SmartDeviceMonitor for Admin.
B On the [Group:] menu, point to [Yes], and then click [IPv4], [IPX/SPX] or [IPv4
SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using IPv4 SNMPv3, enter the user authentication.
C Select the machine whose settings you want to make.
To make settings for all machines in the selected group, select no machine.
D On the [Group:] menu, point to [Energy Save Mode], point to [Set Individually] to
make the settings for only the selected machine or point to [Set By Group] to
make the settings for all machines in the selected group, and then click [On]
or [Off].
E Quit SmartDeviceMonitor for Admin.
Note
❒ For details about the setting for Energy Save mode, see SmartDeviceMonitor
for Admin Help.