Remote Maintenance by telnet
65
2
bonjour (rendezvous)
Use the “bonjour (rendezvous)” command to display bonjour (rendezvous) - related
settings.
❖ View settings
Bonjour settings are displayed.
msh> bonjour
❖ Bonjour service name setting
You can specify the bonjour service name.
msh> bonjour cname “computer name”
• The computer name can be entered using up to 63 alphanumeric characters.
❖ Bonjour Installation location information setting
You can enter information about the location where the printer is installed.
msh> bonjour location “location”
• Information about location can be entered using up to 32 alphanumeric characters.
❖ Setting order of priority for each protocol
diprint:
msh> bonjour diprint [0–99]
lpr:
msh> bonjour lpr [0–99]
ipp:
msh> bonjour ipp [0–99]
You can specify the order of priority for “diprint”, “lpr”, and “ipp”. Smaller
numbers indicate higher priority.
❖ IP TTL setting
msh> bonjour ip ttl {1-255}
You can specify the IP TTL (the number of routers a packet can pass through).
Note
❒ The default is 255.
To Next Page
Loading...
