Remote Maintenance by telnet
77
2
route
Use the “route” command to view and control the routing table.
❖ Specified route information display
msh> route get “destination”
•Specify the IPv4 address to destination.
“0.0.0.0” cannot be specified as destination address.
❖ Enabling/disabling specified IPv4 destination
msh> route active {host|net} “destination” {on | off}
• You can turn the specified destination on or off. Host becomes the default setting.
❖ Adding IPv4 Routing Table
msh> route add {host|net} “destination” “gateway”
• Adds a host or network route to “destination”, and a gateway address to
“gateway” in the table.
• Specify the IPv4 address to destination and gateway.
• Host becomes the default setting.
❖ Setting the Default IPv4 Gateway
msh> route add default “gateway”
❖ Deleting specified IPv4 destination from Routing Table
msh> route delete {host|net} “destination”
• Host becomes the default setting.
• IPv4 address of destination can be specified.
❖ Setting IPv6 Default Gateway
msh> route add6 default gateway
❖ Adding a specified IPv6 destination to Routing Table
msh> route add6 {destination} prefixlen gateway
• Specify the IPv6 address to destination and gateway.
❖ Deleting a specified IPv6 destination from Routing Table
msh> route delete6 {destination} prefixlen
• Specify the IPv6 address to destination and gateway.
❖ Display information about a specified IPv6 route information
msh> route get6 {destination}
• Specify the IPv6 address to destination and gateway.
❖ Enabling/disabling a specified IPv6 destination
msh> route active6 {destination} prefixlen {on | off}
❖ Route initialization
msh> route flush
Note
❒ The maximum number of IPv4 routing tables is 16.
❒ The maximum number of IPv6 routing tables is 2.
❒
Set a gateway address when communicating with devices on an external network.
❒ The same gateway address is shared by all interfaces.
❒ “Prefixlen” is a number between 1 and 128.
To Next Page
Loading...
