Remote Maintenance by telnet
67
2
dhcp
Use the "dhcp" command to configure DHCP settings.
❖ View settings
The following command displays the current DHCP settings.
msh> dhcp
❖ Configuration
You can configure DHCP.
msh> dhcp “interface_name” {on|off}
• Click {on} to enable dhcp. Click {off} to disable DHCP.
• If the DNS server address and domain name are obtained from DHCP, be
sure to click {on}.
• wlan can be specified only when the IEEE 802.11 interface is installed.
❖ Current interface priority configuration display
msh> dhcp priority
❖ Interface priority configuration
msh> dhcp priority “interface_name”
• You can select which interface has DHCP parameter priority.
• Priority settings are available when multiple interfaces are installed.
❖ DNS server address selection
msh> dhcp dnsaddr {dhcp | static}
• Specify whether to obtain the DNS server address from the DHCP server
or use the address set by a user.
• To obtain the DNS server address from the DHCP server, specify "dhcp".
To use the address set by a user, specify "static".
❖ Domain name selection
msh> dhcp domainname {dhcp | static}
• Specify whether to obtain the domain name from the DNS server or use the
domain name set by a user.
• To obtain the domain name from the DHCP server, specify "dhcp". To use
the domain name set by a user, specify "static".
Reference
p.121 “Using DHCP”
p.69 “dns”
p.70 “domainname”
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
To Next Page
Loading...
