Monitoring and Configuring the Printer
64
2
autonet
Use the “autonet” command to configure AutoNet parameters.
❖ View settings
The following command displays the current AutoNet settings:
msh> autonet
❖ Configuration
You can configure AutoNet settings.
msh> autonet {on|off}
• {on} means "active" and {off} means "inactive".
❖ Current interface priority configuration display
msh> autonet priority
❖ Interface priority configuration
msh> autonet priority “interface_name”
• You can give interface's AutoNet parameter priority.
• Priority settings are available when multiple interfaces are installed.
• wlan can be specified only when the IEEE 802.11b interface is installed.
Note
❒ If an interface is not selected, the current interface connection settings remain
in effect.
❒ For details about AutoNet, refer to autonet parameters.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11b interface
To Next Page
Loading...
