Remote Maintenance by telnet
85
2
spoolsw
Use the “spoolsw” command to view and configure Job Spool settings.
You can only specify diprint, trap, lpr, ipp, ftp, sftp, and smb(TCP/IP) protocol.
• The “spoolsw” command for configuring Job Spool settings is available only
when the optional hard disk is installed.
❖ View settings
The Job Spool setting appears.
msh> spoolsw
❖ Job Spool setting
msh> spoolsw spool {on|off}
Note
❒ Specify "on" to enable Job Spool, or "off" to disable it.
❖ Resetting Job spool setting
msh> spoolsw clear job {on|off}
• When the printer power is cut during job spooling, this determines whether
to reprint the spooled job.
❖ Protocol configuration
msh> spoolsw diprint {on|off}
msh> spoolsw lpr {on|off}
msh> spoolsw ipp {on|off}
msh> spoolsw smb {on|off}
msh> spoolsw ftp {on|off}
msh> spoolsw sftp {on|off}
• You can specify the settings for diprint, lpr, ipp, ftp, sftp, and smb.
ssdp
Use the “ssdp” command to view and configure SSDP settings.
❖ View settings
msh> ssdp
❖ Setting effective time
msh> ssdp profile {1801–86400}
The default is 10800 seconds.
❖ Advertise packet TTL settings
msh> ssdp ttl {1–255}
The default is 4.
To Next Page
Loading...
