1801
[Motor Speed Adj]
This SP adjusts the speed of the motor. The motor speed can be adjusted to correct
images that appear scratchy or of uneven density. This can occur when:
• Copying originals with large quantities of black.
• Copying originals with a large quantity of black near the trailing edge.
• Printing multiple copies of positive/negative (reverse) images.
1-801-011 Exit Reverse E [-4.0 to 4.0 / 0.0 / 0.1%/step]
1907
[Paper Timing Adj]
Adjusts the timing of paper feed. (A "+" setting broadens paper feed interval, a “-”
setting narrows paper feed interval.)
1-907-005 Reverse Stop Posi E
[-10 to 10 / 0 / 1mm/step]
Adjusts the reverse stop timing of the range
from the Registration Sensor Off to the Paper
Exit Inverter motor.
Makes it slower (+) or faster (-) than the
default.
1-907-015 Re-Feed Stop Posi E
[-10 to 10 / 0 / 1mm/step]
Adjusts the reverse stop timing of the range
from the duplex entrance sensor On to the
duplex clutch.
Makes it slower (+) or faster (-) than the
default.
1908
[Paper Timing Adj]
Adjusts the timing of paper feed. (A "+" setting broadens paper feed interval, a “-”
setting narrows paper feed interval.)
1-908-015 Junc Gate SOL:On E
[-10 to 10 / 0 / 1mm/step]
1-908-017 Junc Gate SOL:Off E
1921
[Fact Lead Edge Reg]
• Increasing a value: an image is moved to the trailing edge of paper.
• Decreasing a value: an image is moved to the leading edge of paper.
3. Appendices: SP Mode Tables
24
To Next Page
Loading...
