Service Program Mode
D017/D018/D019/D020 5-2 SM
SP Mode (Service). Includes all the options in the SP displays for normal maintenance
and adjustments.
SSP Mode (Special Service). Includes the normal SP modes and some additional
options in the SP displays not required for normal settings and adjustments. (Most are
marked “DFU” in the following tables.) Do not change these important settings
needlessly. For details, contact your supervisor.
Entering and Exiting SP mode
Entering the Service Mode.
1. Press the Clear Mode (S) key.
2. Use the keypad to enter “107”.
3. Hold down the Clear/Stop (D) key for at least 3 seconds.
To enter the Normal Service Mode:
1. On the touch-panel, press Copy SP.
To enter the Special Service Mode:
1. Hold down the button, then press Copy SP.
2. Press Exit two times to return to the copy window.
Use SP2902 to print a test pattern (see ‘Test Pattern Printing’).
SP Mode Button Summary
Here is a short summary of the touch-panel buttons.
Opens all SP groups and sublevels.
Closes all open groups and sublevels and restores the initial SP mode display.
Opens the copy window (copy mode) so you can make test copies. To return to the SP