SP2xxx: Drum
D017/D018/D019/D020 5-34 SM
Toner End Clear
2928*
Clears the toner end condition. Press Execute on the touch panel to clear
the toner end condition without adding new toner.
When you press Execute, the following are cleared:
Toner end indicator (goes out)
Toner near-end counter
Toner near-end level
When making a lot of copies after changing this setting to “1”, the carrier
may be attracted to the drum when the toner runs out, which may damage
the drum.
2929* Vref Adjustment
Upper Limit
1
Adjusts the upper limit for Vref. [0.5 to 3.5 / 3.10 / 0.05 V/step]
Lower Limit
2
Adjusts the lower limit for Vref. [0.5 to 3.5 / 1.40 / 0.05 V/step]
TD Sensor Manual Setting
2930*
Adjusts the TD sensor output. DFU
[0 to 5 / 0.0V / 0.05V/step]
TD (V/wt%) Setting
2931*
Adjusts the TD sensor sensitivity (coefficient: S) for toner density control.
DFU
[0.01 to 1.50 / 0.4 / 0.01/step]
Toner Density Control Level
2932*
Adjusts the toner density control threshold level.
[0 = Normal / 1 = Dark / 2 = Light / 3 = Darker / 4 = Lighter]
To Next Page
Loading...
